XTI Library (libxti.a)
int fd) ;
Interfaces documented on this reference page conform to industry standards as follows:
Refer to the standards(5) reference page for more information about industry standards and associated tags.
The following table summarizes the relevance of input parameter data before and after t_bind() is called:
|Parameter||Before Call||After Call|
Notes to Table: This is a meaningful parameter. This is not a meaningful parameter. Specifies a file descriptor returned by the t_open() function that identifies an active, previously bound local transport endpoint.
The t_bind() function can be called only in the T_IDLE transport provider state.
The t_unbind() XTI service function is used in connection-oriented and connectionless modes to disable the transport endpoint, specified by the file descriptor that was previously bound by a t_bind() call. When t_bind() completes, no further data destined for this transport endpoint or events are accepted by the transport provider. An endpoint that has been disabled using t_unbind() can be enabled by a subsequent call to t_bind().
Upon successful completion, a value of 0 (zero) is returned. Otherwise, a value of -1 is returned and t_errno is set to indicate the error.
If the t_unbind() function fails, t_errno is set to one of the following values: File descriptor fd is not a valid transport endpoint. This function was issued in the wrong sequence. An asynchronous event occurred at the transport endpoint specified by the fd parameter. A system error occurred during execution of this function. This error indicates that a communication problem has been detected between XTI and the transport provider for which there is no other suitable XTI(t_errno).
Functions: t_bind(3) delim off