Manual Pages
Table of Contents
ups - controls the monitoring of UPS' (Uninterruptable
Power Supply'(s))
ups add [-c <community>] <IP Address>
ups [ disable | enable ] [ all | <IP Address> ]
ups status
ups set-limits [ all | <IP Address> ] <critical-time
(secs)> <warn-time (secs)>
ups print-limits [ all | <IP Address> ]
The ups command controls the monitoring for the UPS'
(Uninterruptable Power Supply('s)).
(Intentionally left blank)
add [-c <community>] <IP Address>
Adds a UPS to be monitored by the environmental
monitoring software of the filer.
disable [ all | <IP Address> ]
Disables either all UPS' or just the UPS with the
<IP Address>.
enable [ all | <IP Address> ]
Enable either all UPS' or just the UPS with the <IP
Address>.
status
Gives status for all known UPS'.
set-limits [ all | <IP Address> ] <critical-time (secs)>
<warn-time (secs)>
Sets critical and warning time for either all UPS'
or just the UPS with the <IP Address>.
print-limits [ all | <IP Address> ]
Prints critical and warning time for either all
UPS' or just the UPS with the <IP Address>.
If both partners are on separate UPS' and one UPS goes to
battery and subsequently shuts down. The partner will not
be able to access the disks of the filer that has lost
power. One solution would be to have both partners monitor
both UPS'. In this case if one UPS went to battery and
subsequently shuts down both partners would be cleanly
shut down.
ups status
produces
ups: global status is Disabled.
Table of Contents