Manual Pages
Table of Contents
na_rmc - commmands for use with a remote management controller
rmc help
rmc setup
rmc status
rmc test email <message> | reset
The rmc command is used with a remote management controller
(RMC), if one is present. Using this command, you
may get the status of an RMC and test an RMC. Configuration
of an RMC can be performed by using the setup command
or by using the autosupport and rmc options.
-
help
- Display a list of remote management
controller (RMC) commands.
-
setup
- Interactively configure a remote management
controller.
-
status
- Display the current status of a remote
management controller.
test { email <message> | reset }
Perform tests on the remote management
controller. The email test forces a
remote management controller to send a
test email to all email addresses in
the option list autosupport.to. The
reset test forces a remote management
controller to reset itself and perform
a self-test.
This command only acts upon a remote management controller
that is local to the system.
rmc status
might produce:
Retrieving the current status of remote management controller:
Detected internal cable
Detected external power supply
Detected LAN cable
na_setup(1), na_options(1)
Some of these commands might pause before completing while
the remote management controller is queried. This is normal
behavior.
Table of Contents