logo
Manual Pages
Table of Contents

NAME

na_rlm - commmands for use with a Remote LAN Module (RLM)

SYNOPSIS

rlm help rlm reboot rlm setup rlm status rlm test autosupport rlm test snmp rlm update

DESCRIPTION

The rlm command is used with a Remote LAN Module (RLM), if one is present. Using this command, you may get the status of an RLM and test an RLM. Configuration of an RLM can be performed by using the setup command.

OPTIONS

help
Display a list of Remote LAN Module (RLM) commands.
reboot
Causes the RLM to reboot. If your console connection is through the RLM it will be dropped. The reboot command forces a Remote LAN Module (RLM) to reset itself and perform a self-test.
setup
Interactively configure a Remote LAN Module (RLM).
status
Display the current status of a Remote LAN Module (RLM).
test autosupport Performs autosupport test on the Remote LAN Module (RLM). The autosupport test forces a Remote LAN Module (RLM) to send a test autosupport to all email addresses in the option list autosupport.to.
test snmp
Performs snmp test on the Remote LAN Module (RLM). The snmp test forces a Remote LAN Module (RLM) to send a test snmp trap to all traphosts set in snmp command snmp traphost.
update
The RLM firmware is updated. This may be a time consuming operation. Before issuing this command , you need to execute the `software install' command to get the new firmware image. The RLM will be rebooted at the end of this operation.

CLUSTER CONSIDERATIONS

This command only acts upon a Remote LAN Module (RLM) that is local to the system.

EXAMPLES

rlm status Example output with both IPv4 and IPv6 configuration: 
                Remote LAN Module           Status: Online
                        Part Number:        110-00057
                        Revision:           D0
                        Serial Number:      403516
                        Firmware Version:   4.0
                        Mgmt MAC Address:   00:A0:98:06:F1:9B
                        Ethernet Link:      up, 100Mb, full duplex, auto-neg complete
                        Using DHCP:         no
                IPv4 configuration:
                        IP Address:         172.20.1.2
                        Netmask:            255.255.224.0
                        Gateway:            172.20.128.1
                IPv6 configuration:
                        Global IP:          fd20:d91b:fb35:202::b3ff
                        Prefix Length:      64
                        Gateway:            fd20:d91b:fb35:202::1
                        Router Assigned IP: fd20:d91b:fb35:202:2a0:78ff:fd06:f29b
                        Prefix Length:      64
                        Link Local IP:      fe80::2b0:78ff:de06:f19c
                        Prefix Length:      64

SEE ALSO

na_setup(1), na_options(1)

NOTES

Some of these commands might pause before completing while the Remote LAN
Module (RLM) is queried. This is normal behavior.
Table of Contents