Manual Pages
Table of Contents
na_license - license Data ONTAP services
license [service = code] ...
DEPRECATED, use one of the following alternate forms
instead.
license add code ...
license delete service ...
The license command enables you to enter license codes for
specific Data ONTAP services. The license codes are provided
by Network Appliance. With no arguments, the
license command prints the current list of licensed services,
their codes, the type of license, and, if it is a
time limited license, the expiration date. It also shows
the services that are not licensed for your filer, or if a
time limited licensed service has expired.
The filer is shipped with license codes for all purchased
services, so you should only need to enter the license
command after you have purchased a new service or after
you reinstall the file system.
To disable a license, use `license delete service'.
All license codes are case-insensitive.
The following list describes the services you can license:
a_sis for Advanced Single Instance Storage available
only on Nearstore(R) platforms.
cifs for CIFS.
cluster for clusters.
cluster_remote for remote clustering.
disk_sanitization for disk sanitization.
fcp for FCP.
gateway for the generic Gateway product.
gateway_hitachi for the Hitachi Gateway product.
http for HTTP.
iscsi for iSCSI.
nearstore_option for Nearstore(R) personality on a
filer.
nfs for NFS.
rapid_recovery for Restore-on-Demand for SnapVault
Primary.
smdomino for SnapManager for Domino
smsql for SnapManager for SQL
snapmanagerexchange for SnapManager for Exchange
snapmirror for SnapMirror
snapmirror_sync for synchronous SnapMirror
snaprestore for SnapRestore.
snaplock for SnapLock volume support.
snaplock_enterprise for SnapLock Enterprise volume
support.
snapmover for SnapMover support.
snapvalidator for SnapValidator support.
sv_linux_pri for SnapVault Linux Primary
sv_ontap_pri for SnapVault ONTAP Primary
sv_ontap_sec for SnapVault ONTAP Secondary
sv_unix_pri for SnapVault Unix Primary
sv_windows_pri for SnapVault Windows Primary
sv_windows_ofm_pri for SnapVault Windows Open File
Manager Primary
syncmirror_local for Local SyncMirror
vfiler for MultiStore
vld for SnapDisk
Capacity based licenses will display the configured
filesystem limit. These capacity limits will be
checked weekly, and any license whose limit is
exceeded will cause an EMS/syslog notification to
occur.
The following example enables NFS:
toaster> license add ABCDEFG
nfs license enabled.
nfs enabled.
The following example disables CIFS:
toaster> license delete cifs
unlicense cifs.
cifs will be disabled upon reboot.
You must enable the licenses for the same Data ONTAP(tm)
services on both filers in a cluster, or takeover does not
function properly. When you enable or disable a license
on one filer in a cluster, the filer reminds you to make
the same change on its partner.
You can disable the cluster license only if both of the
following conditions are true:
The filer is not in takeover mode.
You have used the cf disable command to disable
cluster failover.
-
0
- The command completed successfully.
-
1
- The command failed due to unusual cirumstances.
-
2
- There was a syntax error in the command.
-
3
- There was an invalid argument provided.
na_partner(1)
Table of Contents