pam_faildelay is a PAM module that can be used to set the delay on failure per-application.
is given, pam_faildelay will use the value of FAIL_DELAY from
Turns on debugging messages sent to syslog.
Set the delay on failure to N microseconds.
MODULE SERVICES PROVIDED
service is supported.
Delay was successful adjusted.
The specified delay was not valid.
The following example will set the delay on failure to 10 seconds:
auth optional pam_faildelay.so delay=10000000
pam_faildelay was written by Darren Tucker <email@example.com>.
- MODULE SERVICES PROVIDED
- RETURN VALUES
- SEE ALSO
This document was created by
using the manual pages.
Time: 04:17:50 GMT, September 24, 2010