Content-type: text/html Man page of trpt

trpt

Section: Maintenance Commands (8)
Index Return to Main Contents
 

NAME

trpt - Transliterates protocol trace  

SYNOPSIS

trpt [-afjst] [-p address]  

FLAGS

Print the values of the source and destination addresses for each packet recorded, in addition to the normal output. Follows the trace as it occurs, waiting briefly for additional records each time the end of the log is reached. Lists the protocol control block addresses for which trace records exist. Shows only trace records associated with the protocol control block specified in hexadecimal by the address variable.
You must include a space between the -p flag and the address variable when you specify this flag. Prints a detailed description of the packet-sequencing information, in addition to the normal output. Prints the values for all timers at each point in the trace, in addition to the normal output.
 

DESCRIPTION

The trpt command, used for debugging sockets, queries the buffer of Transmission Control Protocol (TCP) trace records. The TCP trace record buffer is created when a socket is marked for debugging with the setsockopt(2) subroutine. The trpt command queries the buffer and then prints a description of the trace records.

When you specify no options, the trpt command prints all the trace records found in the system and groups them according to their TCP/IP connection Protocol Control Block (PCB).

If you are debugging a system file other than the default, the system argument can be used to replace the default.

Before you can use the trpt command, you must do the following: Isolate the problem and mark for debugging the socket or sockets involved in the connection. Find the address of the protocol control blocks associated with these sockets by using the netstat -aA command. Then, you can run the trpt command, using the -p flag to supply the associated protocol control block addresses. You can specify multiple -p address flags with a single trpt command.

The -f flag can be used to follow the trace log once it is located. The -j flag can be used to check for the presence of trace records for the socket in question.

If the system image does not contain the proper symbols to find the trace buffer, the trpt command cannot succeed.  

FILES

Specifies the command path  

RELATED INFORMATION

Commands: netstat(1)

Functions: setsockopt(2) delim off


 

Index

NAME
SYNOPSIS
FLAGS
DESCRIPTION
FILES
RELATED INFORMATION

This document was created by man2html, using the manual pages.
Time: 02:40:28 GMT, October 02, 2010