Content-type: text/html Man page of snmp_manual_setup

snmp_manual_setup

Section: Environments, Tables, and Troff Macros (7)
Index Return to Main Contents
 

NAME

snmp_manual_setup - Describes how to manually set up the Simple Network Management Protocol (SNMP) agent  

DESCRIPTION

Tru64 UNIX provides the snmpd daemon as the Simple Network Management Protocol (SNMP) agent. The SNMP agent is started at boot time.  

Manually Configuring the snmpd Daemon

To manually configure the snmpd daemon, perform the following steps: Edit the /etc/snmpd.conf file.

The /etc/snmpd.conf file defines the initial values for three MIB variables, as well as access control based on community names.
For more information, see the snmpd(8) reference page. Edit the /etc/rc.config file by using the /usr/sbin/rcmgr command. The syntax for the /usr/sbin/rcmgr command is as follows:
/usr/sbin/rcmgr set variable value
To edit the /etc/rc.config file and add the required information, enter the following command:
# /usr/sbin/rcmgr set COMMON_AGENT_CONF NO

For the changes to take effect, restart the snmpd daemon using the following commands:

# /sbin/init.d/snmpd stop # /sbin/init.d/snmpd start  

RELATED INFORMATION

syslog(3), snmpd(8)

Network Administration delim off


 

Index

NAME
DESCRIPTION
Manually Configuring the snmpd Daemon
RELATED INFORMATION

This document was created by man2html, using the manual pages.
Time: 02:40:20 GMT, October 02, 2010