Man page of ERR_set_mark
Section: OpenSSL (3SSL)
Return to Main Contents
ERR_set_mark, ERR_pop_to_mark - set marks and pop errors until mark
ERR_set_mark() sets a mark on the current topmost error record if there
ERR_pop_to_mark() will pop the top of the error stack until a mark is found.
The mark is then removed. If there is no mark, the whole stack is removed.
ERR_set_mark() returns 0 if the error stack is empty, otherwise 1.
ERR_pop_to_mark() returns 0 if there was no mark in the error stack, which
implies that the stack became empty, otherwise 1.
ERR_set_mark() and ERR_pop_to_mark() were added in OpenSSL 0.9.8.
- RETURN VALUES
- SEE ALSO
This document was created by
using the manual pages.
Time: 04:14:14 GMT, September 24, 2010